The material of the automatic edge banding machine itself is metal, and the object it operates on is also metal. The working principle is to use the friction and impact between metals to achieve the purpose of cleaning and optimization. Therefore, wear and tear during the working process of the edge banding machine is inevitable. And the wear and tear will be more serious. So the biggest point in maintenance is the use of lubricating oil. The purpose of adding lubricating oil is to slow down the wear of the machine and prolong the time it takes to be scrapped. However, lubricating oil cannot be overused and the effect of improving wear is not particularly obvious. . Therefore, the key is to maintain the accessories of the edge banding machine. The machine should be inspected regularly and damaged components should be replaced in time, especially the damaged steel balls. Otherwise, the damaged steel balls will wear the castings.

Automatic edge banding machine equipment installation steps:

1. Remove the packaging of fixed mechanical parts.

2. Place the machine on the ground and adjust the level.

3. Fix the rolled edge banding material on the machine with a storage turntable.

4. Connect the external power cord, 220V50HZ three-phase four-wire power supply, and the total power cord diameter must be more than 4 square centimeters.

5. Connect the air source.

6. Connect the vacuum pipe to the dust removal equipment.

7. Check whether the voltage is normal and ensure that the compressed air is sufficient and dry.